Not too sure what to do about the harness stuff...still thinking about it.
Probably going to have to roll with the 3 point until after next weekend.
Messed around the garage today for a little bit after a really rough night last night.
What I started with this morning.
So you can see the brackets here in the photos, they are really nice quality and the hardware came with them. They adapt the crown vic frontend to the C5 corvette PBR aluminum calipers and run the 14" GT500 rotors.
The Rotors needed to be opened up at the center of the hub to fit over the crown vic.
You can get the idea from the photos of the size difference from the photos. Stockers are 12" and the upgrades are 14"
I had to make some provisions to the calipers for the smaller wheels..you can see I made some changes with the grinder to these. I have about 2mm clearance now to the caliper from the wheel...its tight but it should be just fine.
I love the fact that it is OEM looking but biggg..
I likey.