Quote:
Originally Posted by JsTA
I don't think I would worry about the LS9's on the smaller bore. People have even ran them on 4.8's with no issue. Plus they are reusable so just pulling the heads won't affect anything.
|
Hi there, there are a lot of folks that do use them with success on small bore motors, but that doesn't necessarily make it the right direction to go in my opinion. Also, because of my own stupidity I think I forgot to install an alignment dowel for one of the heads. If the gaskets look good I will absolutely save them for the 408 cube motor I intend to build in the future.
I should have a good update for this weekend! Got a ton of parts in and should be able to start working on the actual car....a novel concept!
Thanks for your interest!