03-30-2016, 11:29 AM
|
|
Senior Member
|
|
Join Date: Jun 2013
Posts: 122
Thanks: 1
Thanked 6 Times in 5 Posts
|
|
Quote:
Originally Posted by toddoky
No, the Hooker 1st-gen LS swap system is not compatible with the use of 1/2-height body mounts. This is primarily due to the way the crossmember is designed to extend up into the formed pockets in the floor to maximize exhaust system ground clearance (photo attached), which leaves only about 1/8" between the top of the crossmember and the floor pocket sheet metal. It would take quite a bit of sheet metal work to make everything play nice together if you wanted to use 1/2 height body mounts.
|
Thanks toddoky.
|