I've got a few updates to share...
Almost done with the air intake tube. I just need to weld on the MAF bung and then have it powder coated. I also finished making all the AC and heater hoses.
I finished making the oil cooler and accusump lines (the zip ties are temporary until I get some actual hose separators).
The exhaust is done.
And I figured out my radiator hoses. The upper hose is a Gates 22147 with 1" trimmed of the radiator end. The lower hose is a Gates 22437 with 1" trimmed off the radiator end and about 4.5" trimmed off the water pump end.
I'm sure there's a bunch of things left to do that I can't think of at the moment, but the only big things now are the engine harness, AC harness, put the interior back together, and a dyno tune once it's up and running.