Its only been a few days since my last update, but it has been a
busy few days!
-Installed Ram Clutch (part 98931HD, single disk ceramic/bronze disk material)
-Installed engine into engine bay
-3M Scotchbrite brushed the intake manifold and valve covers, sprayed them with Dupli-color clear engine paint to seal them.
-Intake manifold was too tall at the throttle body mounting flange, so I had to cut it down and reshape the flange to clear the hood. I removed about half an inch from the flange, and flipped the throttle body upside down. It should actually work better this way, since my throttle cable comes from the driver side anyways.
Brown Truck Santa showed up on Monday.
Continued...