Baby steps, small weekday projects.
Trying to make time to get into the garage and knock out small items during the week since I cant dedicate significant time to the garage (usually 2-3hours MAX during the week days).
I got out there yesterday to sort the steam vent concern. The kit I had I made look decent I think.
Plenty of room at the rear of the engine. Sits well under the map sensor/etc.
Front is a little closer, specifically the fitting by the fuel line crossover.
There is a gap, but it's paper thin.
The line off the tee fitting on the front will go back to the radiator here
I ordered the 1/4" NPT to -4 AN adapter so I can complete that line and have it follow the radiator hose route. Should be very clean looking once completed.
William