Dreamin Ta's
Lance,
yes threaded thru... locktight red then the sheetmetal
Not sure how to use the new welder my buddy has at my
shop... need to get a quick lesson.... so just went with this for now
After 28 years these things were bouncing around.. if I have
an issue I can get to them now..Nutserts were a pain to get out
I have a big gash in my arm from the sharp rotor when trying to pry them out
Mikey,
yes time to go to Crows.. mine can run even if the hood is
not on it.. would like to get the gear changed but too much
going on at work right now
Bob
|