Quote:
Originally Posted by GregWeld
Nice Tim!
|
Thanks GDub.
Quote:
Originally Posted by Che70velle
Thanks for posting Tim. Have you used an ID mic to get wear numbers? Is this at 3k miles?
Been wondering how they are holding up.
|
This was after about 2,000 miles of mixed street and racing. I did not check the size but you cannot feel anything, in fact I can still see some of the tool marks in the polished area so I doubt you would be able to measure any difference. I fully expect these bushing to eventually wear out but I would much rather have the bronze dust than the hardened steel dust from the needle bearings.