Thread: Dakota Digital VHX gauge control through BIM-01-2 with GMPP harness. How?
View Single Post
  #1  
Old 09-19-2016, 08:11 AM
samckitt's Avatar
samckitt samckitt is offline
Senior Member
  
Join Date: Dec 2005
Location: Carrollton, VA
Posts: 348
Thanks: 1
Thanked 15 Times in 9 Posts
Default Dakota Digital VHX gauge control through BIM-01-2 with GMPP harness. How?
I recently purchased a Dakota Digital BIM-01-2 module to drive the VHX gauges from the LS ECM vs running all new sensors & wires for it. However the GMPP ALDL connector doesn't have the proper terminals available for the DD module to get the signal, instead these wires are in a separate connector in the harness.

So did you add these terminals to the ALDL connector, or connect the BIM module directly to this other connector in the harness to get the BUS signal?
__________________
Scot
86 Monte SS
LS2/T56 Magnum
Reply With Quote