[woody80z28]

Guess it's time to update this thread again...even though it will be depressing how little I've had time to do! haha

Originally Posted by woody80z28, post: 3459705, member: 12782

Wow, haven't updated in while. Guess that's ok...haven't gotten much done. Working a ton of OT, but that helps the build fund.

Got the pins done. Actually used the burned up pivots from the SPC arm! haha



Thought briefly about just running with the craptastic panel fitment from the Goodmark door skins...and then thought better of it. Welding the gap in the rear gave me a little warpage, and I found a different technique online. With this technique you use 1/8" solid round stock. A lot less welding. Got it looking pretty good now. Gonna mud the driver's side before I weld the pass to see if there is anything I can improve on. But I think it's gonna be decent.

Originally Posted by woody80z28, post: 3464767, member: 12782

I think the door gap saga is now over...pretty happy with the fitment. I highly recommend the 1/8 solid rod method to anyone tasked with this crap. haha

Next issue: fiberglass! Hood and rear spoiler fitment. I am so highly excited... :screwup: