Quote:
Originally Posted by samckitt
OK so I called them today & talked to a different tech. This one said I needed pins 6 & 14 just like you said. I tested the cable & its good, for some reason somethign isnt getting a connection when I put it in the ALDL connector, but if I put an extension cable in between them, it works.
Oil pressure doesnt work though. Original tech said if oil sensor has 3 wires it would work, well it didnt.
I still want to wire it direct, it only needs two wires. You suggest I tap into the back of the ALDL wires, or from the ECM? And do I need to twist them together?
THanks
|
Can't you use the stock oil pressure sensor and read it off the bus? That is what I did. Same for temperature, stock sender and read it off the bus.
Sorry for the bad advice on which pin the data is on.
Don