Quote:
Originally Posted by samckitt
OK so I called them today & talked to a different tech. This one said I needed pins 6 & 14 just like you said. I tested the cable & its good, for some reason somethign isnt getting a connection when I put it in the ALDL connector, but if I put an extension cable in between them, it works.
Oil pressure doesnt work though. Original tech said if oil sensor has 3 wires it would work, well it didnt.
I still want to wire it direct, it only needs two wires. You suggest I tap into the back of the ALDL wires, or from the ECM? And do I need to twist them together?
THanks
|
I'm not certain how to direct wire the CAN connection since there is a terminator resistor at each end of it. Maybe call DD again?