[lsuguy]

SO the PSI harness is very well made and is laid out very nice but I can't leave well enough alone. I will be hiding and re-routing just about every wire in the car so I went ahead and picked up some techflex to replace all of the plastic split loom. I will try to post pictures as I work through this part of the build but it will be a long, tedious process lol.





My Wegner front drive setup also arrived. The water pump came in just as a stock cast LS2 water pump so I spent a little time with the dremel before painting the water pump. I also pulled the barbs for the heater hoses and tapped those for AN fittings. Last you will see the inlet/outlet are setup with -20 AN fittings to match my Autorad radiator.



And also some pictures of the front drive system in place. Only thing not installed is the ATI damper and crank pulley but those will be going on soon.







And I will close with some overall shots of the engine bay. I went ahead and installed the driver side fender and inner fender so I can start figuring out how to the plumb everything in this car. Pretty much everything is being done in AN hoses and AN Fittings and hardline so I expect this phase to take me quite a while to complete. Thanks for looking!