[gerno]

A bit more progress has been made over the last week. The LCAs are all welded up with shock mounts added. I also tacked up the sway bar which has been driving me insane. Finally figured out a configuration that has zero binding during suspension compression, zero steering or wheel clearance issues and tucks above the x-member during suspension compression. I'm going to wait to weld it up completely until the frame is fully complete.

Next step is to clearance the frame a bit more for the tie rods during suspension compression and full turn, check the alignment to make sure I didn't screw anything up and then start to fill in all the holes I cut in the frame.