[CJD Automotive]

Got the front clip in epoxy and started mocking up the rear. As you can see in this pic, the X brace that was in my blueprint is actually touching the 3 link at the housing. This took a lot of time fitting and welding, guess I'll cut that out...





It wasn't until I cleaned and epoxied it that I noticed some pretty sub standard welds. Ron said it's "race car quality", not show. I'll let you decide.








Got Fuel Safe working on the cell.

I'm using a Holley VR2 brushless pump, internally mounted, that pulls from the custom collector. It also has two internal lift pumps that pull from the corners and fill the collector. Lot of stuff going on/in that cell.