A couple people have asked what's left before paint at KD Hot Rods. Here is the list that Dave and I are working off of.
To Do Paint & Body
Patch Panel underside of Bed
Billet Bed Shims
Smooth Welds on Inner Fenders of Bed
Smooth Tailgate Handle (Just tacked in)
Adjust Hinges on Tailgate
A-Pillar Body Line
Hood Hinges - Possible Billet
Remove Hood Body Line < (= End Body Line on Front Fender >
Inner Fenders - Smooth
Radiator Cover Shroud
Remote Wiper- Complete
Roll Fender Lips on all Four Corners
Interior
Sheet Metal Dash Conversion (Side Panels)
Mount Gauges
Re-Drill Steering Column
Mount Lokar Hood Release
Mount MSD Coil ( Firewall )
HID Headlight Conversion or H4 Conversion
To Do Engine Bay
Billet Master Cylinders
Mount Over Flow Bottle
Mount Power Steering Tank
Mounting tab on Hogan Intake Valley (FPR)
Turbo Support Bracket
Mount AC/Heat Bulkhead
Mount AC Dryer
A/C Condensor Clearence Grille
Radiator Cap
Install Oil Fill Cap / Spout in Manifold
To do Plumbing
Stainess Brake Lines
Braided Stainless Lines on Trans Cooler.
Braided Stainless Oil Cooler Lines
Y-Block to Engine - back to Fuel Cell
Temp Sender - Radiator (keep one hole open)
Upper Radiator Hose
Lower Radiator Hose
PS Lines
Air Lines (Air Ride)
Shifter Cable
Transmission Dip Stick
Electrical Lines
Starter
Remote Battery
A/C Plumbing
To Do Chassis & Suspension
Misc Underside Welding
Cross Brace
Smooth Welds on the Frame
Tie Rod Sleeve (Talk with Kevin)
Bump Stops on Chassis - Front Suspension
Longer Wheels Studs - Front Spindle's
Drive Shaft
Ground Studs - Firewall, Front Frame, Rear Frame
Ground Studs - Interior firewall, Pump Controller, Radio, Amp, MSD Box
|