Forgot to keep this up to date...last update before SEMA and Invitational.
Went through all the suspension, remade the rear axle side panhard bar mount to hopefully get the rear roll center down a bit.
Replaced the rear springs with some 450lbx8" springs and replaced the front springs with 650x10" beehive style springs. Reset all the ride heights to be close to how it was and threw it on the scales. Believe it or not this thing is not horrible My next changes will be much much better weight distribution but for now I have to live with a 3550 lb weight with the race seats and and a 55 front 45% rear weight distribution and 3550 lb total weight.
Then was the brakes. I built some heat shields for the brake lines near the exhaust and covered them with heat tape. Been having some brake issues. Got the shields installed and rebled the fronts. Well the passenger side. Got to the drivers side and started inspecting it and found the lower piston was leaking into the dust shield. Curious if that was letteing air into the system. Replaced the caliper with a new one and bled the crap out of the system. Hoping all is well.
Loaded stuff up and headed south.
We are here in Vegas now...Loading into SEMA tonight as we are one of the last groups to load into the show. I will be there all week long and the truck will be in OPTIMA Alley. Not sure exactly where that is as I have yet to be there
