Forgot 1 more thing. I also didn't like the accessory drive I had and it didn't fit with the shock hoops. I made a prototype of a new setup with the PS lower on the driver side and the alternator on the bottom passenger side. I also tried to focus on maximum belt wrap. This is just form MDF but I'll most likely make it from 3/8" aluminum and have it laser cut.
All the parts except the alternator are factory from a 2010 Camaro including the 2 additional idler pulleys. The alternator is a lower amp alternator from a chevy truck because it has a smaller housing. I figure this will be nice in case anything goes out. I can easily get replacement parts locally.
