Quote:
Originally Posted by glassman
Very nice build. Somehow missed this thread.
Love the sheet metal work, this is one area i wished i could've spent more time in.
A couple questions, you going to run stock inner fenders?
Are there stock p#'s from the Spectra tubes?(i'm gonna redo my cold air when car gets back from paint)
Did you have too tunnel for the T-56 with the DSE set up? I didn't but i'm not convinced that its at optimized degrees with not tunneling with my DSE set up.
What drive shaft you going too run?
Cheers, mike
|
Thanks, Mike
Yeah, of all the mods, the floor pans for the exhaust clearance was the best one. It snowed a lot here this winter so I put some time in the garage.
Yes running stock inner fenders.
The part numbers for the Spectrs tubes are:
These are Summit Racing part number,
SPE-97991
SPE-97490
SPE-9749
I'm actually running a stock subframe with a Speedtech Street Fighter setup, with there ATS T-56 crossmember. For the trans tunnel I raised the stock tunnel a couple inches and the front part of the tunnel I had to make a new piece to get the clearance.
As soon as I get the rear end back in the car I'm going to be ordering a Denny's 1350 series 3 inch Nitrous Ready Driveshaft complete with Transmission Slip Yoke.
Hope this helps,
Sandro