[nicks67ca]

These are the best pictures of the interference I have. you can see there are 2 spots that come really close to the frame. It was so close that i could just barely slip on the belt onto the pulley. You can see the blue outline. I cut the 2 lines (one not shown in front of the pulley) going to the bottom of the frame and cut along the bottom just above the welds. I then used a hammer and punch to evenly move the metal back to make a pocket. I then welded it all up and ground everything smooth. I just looks like a soft pocket with smooth transitions. I'll take better pictures when i do the alternator side tomorrow. I think there may have been just enough room on the alternator side but since I got a good process i'll just make it to match the A/C side.