Here are some of the pics from the Shockwave mock up yesterday (based on a 26" tall tire). This is with the 2" Ridetech shock extension, I am hopeful the 1" top will clear the control arm cross shaft. This will give another 1.125"-1.25" of compressed travel but will keep the suspension below its designed operating range. I will mock these up today sometime just to know.
Our bumper is bent up on the driver side so the frontal view looks a little off. The driver side is roughly an inch higher than the passenger.
Looking underneath the bumper at the crossmember.
This picture is a little deceiving because I couldn't get the camera low enough to get the true height. The crossmember is closer to 1.75".
The front frame head just behind the front bumper. Keep in mind that the rear suspension is still at ride height so once it is aired down this height will actually go up.
This is the front cab mount. Keep in mind that the rear suspension is still at ride height so once it is aired down this height will go down.
I uploaded a short video to Facebook of the Shockwaves cycling. I also put it up on our Instagram page (TCI_Engineering) if you don't have Fb.
https://www.facebook.com/Total.Cost....type=2&theater