While I was on lite duty from the Doc, I started working on the dash. I have a billet gauge panel from Eddie MotorSports (now sold at TthePartsPlace) and a factory style dash panel that you need to use the Metron part in. The factory style part gets cut up and most of the middle is removed. Then you install the billet piece between the two out side parts of the factory pieces. They give you little clips which I didn't have much luck with. So I put it together and epoxied it in place. Not sure if this was a good idea but it's what I did.
Here are a couple of pics of it together drying.
I made a little fudge near the heater control opening, you can see it in the first picture. I need to try to fix that without making it worst with my shaky hands.