SEMA, Pleasanton & Scottsdale, 3 weekends in a row working out of town has slowed progress on the C10.
We needed a little room under the cab for intercooler piping.
Still need to roll the edge to add some strength.
Started working on the chromoly center section. Form fitted around the tranny on the bottom side. The two middle tubes aren't mounted yet. There will be a couple cross braces added for the tranny mount & driveshaft loop.
*NOTE* The relationship between the front of the bell housing and the cab mount.
The Torque Arm will end up filling out this space so I needed to devise a way to gain clearance. It took some thought to get the angles right but the bend came out perfect (Even though chromoly deflects so much after being bent).
