Quote:
Originally Posted by WSSix
4th gen drive shaft fit 3rd gens? Should be able to pick one up cheap if so.
You need to be on frrax.com if you're not already. Great site for making fbodies handle.
That looks like a de-coupled TA. That's a serious piece if so. My guess is it was never designed for a T56 only the T5 and 700R4 found in 3rd gens. Honestly, I'd cut the rearward mount off the bottom of the tail housing. Those mounts are were the 4th gen TA mounted to the trans. You could probably slice it at an angle from the side so it doesn't hit the bolt any more and call it done.
|
I'm thinking the same thing Trey. I think I can trim off the bolt hole there and make some room for the bolt head. I believe Spohn makes a T56 crossmember but if I can make this one work then I can save some cash.
I'm also on frrax.com but don't have a build thread.. just using it for research right now. Thanks for the tip though.