In this video I go over cutting/creating the new fuel lines for the build.
I used -8 PTFE Hose for the fuel system - while this hose is a bit harder to setup - I won't have the gas vapor smell that happens with traditional stainless braided rubber hose - plus E85 won't break down this hose type.
Parts/Tools Used:
Fuel Line Quick Disconnect Tool:
http://amzn.to/2z8gOxy
Evil Energy AN Wrench:
http://amzn.to/2z84Eog
Air Powered Drill:
http://amzn.to/2z8wgtP
Chisel Set:
http://amzn.to/2C1bJFS
Pipe Cutter:
http://amzn.to/2ASnGyg
NPT Tap:
http://amzn.to/2z8u71e
Step Drill Bit:
http://amzn.to/2C0cHSJ
PTFE Hose:
http://amzn.to/2ASHNws
AN Adapter Fitting:
http://amzn.to/2AD1XNS
45* AN Fitting:
http://amzn.to/2ymutxk
90* AN Fitting:
http://amzn.to/2ASHrWq
180* AN Fitting:
http://amzn.to/2ym2yhg
90* AN Fitting to 3/8 NPT:
http://amzn.to/2ASmNFV
Russell Fuel Filter:
http://amzn.to/2Cc2rb2
Thanks everyone for all of your support!
Follow me on Instagram:
https://www.instagram.com/bonecrrusherss
Follow me on Twitter:
https://twitter.com/bonecrrusherss
Like me on Facebook:
https://www.facebook.com/bonecrrusherss