Quote:
Originally Posted by MX145
The power outages over the weekend killed my Ruckus wireless controller. After a few failed attempts to repair the onboard flash drive I’m back online after giving up on the proprietary flash and converting my AP’s to standalone. The power outages also caused a few 3D prints and CNC operations to fail.
All that to say I haven’t uploaded the comparison of short vs deep tweeter waveguides but it’s clear the deep waveguide performs better. I took REW RTA measurements at dash center, dash middle, and dash end near pillar, as well as left and right seated head position. My laptop is tied up running the CNC overnight so hopefully I can post the graphs soon.
I’m cutting birch mounting rings for the e430’s I’m planning to fiberglass in the kick panels. It’s going to take days at the 1mm cutting depth and .5mm/s feed rate so I’m hoping upgrading the spindle max from 10k to 30k RPM will allow me to speed things up.
|
Hate it when you have to keep starting over.
