Quote:
Originally Posted by WSSix
Pretty sure that's a factory fuel rail and not an Accel part. The pressure regulator looks to be just a replacement unit for the factory fuel rail.
The silver valve in 3 is the EGR valve. Just block off the manifold with a piece if metal that you bolt down with sealant. You might be able to buy EGR blockoff plates off Ebay or Amazon.
I'm not sure about the intake gasket and cross over block off. I'd just go with the gaskets you took off if they were working. The part number should be pressed into the gasket in the middle.
Intake looks good in black.
|
Thanks for the tips... I did some more research and ended up ordering a Holley fuel pressure regulator that should drop in.
As far as the EGR, I did a bit more research there too and the computer depends on it quite a bit so I purchased a new one. I also ended up going with the same intake manifold gaskets like you suggested, should work out alright!