Version 1.0 of my cluster laying out carbon fiber overlay came out pretty good (pic 1) I however encountered a lifting problem when I started to apply the epoxy and I just couldn't fix it. I pulled all the carbon off and while trying to figure if I should attempt to get the wet epoxy off now or let it dry and sand it down I came to the conclusion that since carbon fabric is relatively cheap that I would let the epoxy tack up and then throw a fresh piece of carbon at it and start from the bottom and work up. This turned out to be successful (pic 2). Tonight after work I'll start the coating process again, this time with a for sure good bond to the housing.
|