Now this is what we have been waiting for.
Quote:
Originally Posted by Blake Foster
YES here is an update. all the parts are designed, we have been waiting one one VERY cool new tool to arrive before we move forward on this project that is scheduled to arrive this week, then we can confirm all the fitment and have the parts laser cut and we will begin install in 2 weeks. we have a COMPLETE front center and rear set up. here is a bit of the run down
Front
Extreme "subframe/ K Member "
AFX / Extreme Spindles
Rack and Pinion
Ron Sutton shocks / coil over
Splined sway bar
and a few other surprises
there will be room for a 315!
mid section
will consist of weld in sub frame connectors Although they technically don't connect the sub frame probably floor stiffening kit would be a better name.
this will allow for the adjustable trans mount and torque arm mount and dual exhaust down the tunnel.
Rear suspension
our standard torque arm.
adjustable panhard bar set up with corrected roll center height adjust ability
our Articulink lower trailing arms
adjustable sway bar
Ron Sutton shock / coil over
we will have a mod for the rear wheel well to fit a 315 also. but as someone said above it is TIGHT!!
additional parts we will have
tunnel mod for trans position
headers
ls and LT motor mounts
mid august is the target to have the suspension installed.
 |