Hey guys,
FS: 383 Stroker
Scat 9000 Crank
GMPP Rods 5.7"
KB Hyp 10:1 Pistons
Clevite Bearings
Stock 5qt pan
stock 400 Balancer
SFI flexplate
Comp Cams 292X
Hyd Flat Tappet
Adv: 292/292
@0.50 244/244
Lift .511/.511 with 1.5 roller rockers
Heads:
http://www.canfieldheads.com/sbc.html
ALUM. Canfield 220cc Race heads
Stainless 2.06/1.65 valves
10 degree keepers
Comp Springs
Paid $2200
Edelbrock Performer RPM Air Gap Intake
Edelbrock Valve Covers
Electric Water Pump
I ran this combo with HEI and a 650 DP with a turbo 350 Trans and 3.73 gears.
I ran 12.14 in a fully dressed Regal. I have video to prove it.
I love this engine, wish I could use it but I am going turbo. She runs on pump gas and always has. Likes 34 degrees of total timing. Has a great street presence, lopey but still good enough vacuum for vac brakes. On an chassis dyno I made 375hp and 440ft/lbs in 90 degree weather and 180degree water temp. Only about 1000-1500 miles on her. Has only been to the strip twice. Mainly just went to cruise-in's. If you have any questions please feel free to PM me.
Asking $4000 intake to pan. I have a carb also.
Jeff