[jasonz28camaro]

I installed the airbar and it was not too bad but had to do a good amount of hammering to get the bar in. The frame rails were spot on, only had to hammer in the front area of the trunk pan where it meets the floor pan and where the airbar bolts to the trunk floor.

This airbar is the "newer style" where the upper arms point inwards rather than outwards. This newer style's mounting plate that bolts up near the tunnel is a little different from what I've seen on the older style airbars, there are 5 bolts and the middle bolt is the center of the airbar. As you can see in the photos the center bolt is off about an inch to the left. I called spoke to Ridetech and showed them the photos and it turns out the floor pan is a little crooked from factory tolerances or it was replaced at some point incorrectly.

[IMG] [/IMG]