Another little issue I ran into was the 3rd member came equipped with a 1310 series yoke rather than the advertised 1330 yoke. See photo below, the width is inline with a 1310 yoke at 3.219", my measurement was 3.211". The 1330 yoke should measure at 3.622". Both curry and ridetech advertisers a 1330 yoke. It made for an interesting couple of trips to the driveshaft shop across town. For some reason, Curry did not believe me and said there was no way because they do not even stock 1310 yokes. After emailing back and forth a few times they agreed to send me the correct yoke and threw in the correct u-joint and u-bolts. I'll install the yoke later down the road when I do the motor/trans swap so I just make one more trip to the driveshaft shop.
[IMG]
[/IMG]