[DWC]

I've been working on the car...I swear. I haven't updated this thread because it's just been boring, redundant filler, then sand, then filler, then sand...

I'm wrapping up the bodywork/filler process on my body shell and was unsure of a few things and I'm hoping someone can provide some insight.

Seam sealer- I'm spraying etch primer next, then spraying 2K urethane primer, then blocking with progressively finer grits. At what point during this process do I apply seam sealer (for instance, where the rear quarter panels meet the taillight panel)?

New body panels- I'm replacing a few panels with AMD repops that are EDP coated. Should they be scuffed>etch primed>2K primed? What about the inner side of the panel- just etch primer or just leave the EDP?

Thanks in advance.

Daniel