I'm finally back at on the Chevelle. Since my last update a lot of things have been pushing this project on to the back burner. We replaced the gravel driveway with concrete (around 146 yds!), got a new front door on the house, I converted the El Camino over to a Ridetech coilover system with a set of custom built (by me) triple adjustable shocks, and we drove to Vegas to attend SEMA. Over the last few days I was able to get most of the main cage structure tacked in place. I've never installed a cage before and I'm using a kit (from Ron Sutton). I don't have any experience to say whether or not the kit is any good (not that it matters anymore), but I think it will be ok for my use.
20181114_114640 by
Yelcamino, on Flickr
20181114_114652 by
Yelcamino, on Flickr
Once I'm done with the main cage, the body is coming off and the chassis is going on a rotisserie that I'm borrowing from Tom Farrington. With access to all the tight joints I should be able to weld it much better than in the car. While it's on the rotisserie, I'll also address some areas under the chassis that were hard to get at while it was on the table.
It may not be Vorshlag quality, but I'm trying my best!
