Quote:
Originally Posted by SSLance
Update pics...
Top of air horn on back side
Somehow I'm going to need to shave about an inch off of the front of spacer and tapered back to a 1/8" or so off the back half to make the housing meet the hood just right with the new setup. |
.
I was looking @ the Edel ProFlo-4 for a sbc combo I have vs. all the parts swapping to go LS. I submitted a question asking which intake the kit was based off of to determine the height of the set-up. Your carb intake is a Perf RPM Q-jet correct? (I understand your new set-up above is diff vs the ProFlo-4)