[CamaroAJ]

This week I got the driver floor bonded together and wrapped with 12k carbon fiber. I ran out of both epoxy and carbon so I wasn't able to get the rest of the floor panels done so I'll have to put that off until I get more.

Today though I got quite a bit done on the firewall. I finished cutting off the upper cowl to access the bottom and got the main middle section shaped, bead rolled and welded in. I'm undecided how I want to finish the passenger side of the firewall so I focused on the driver side and got most of that done. I feel that I'm more than likely going to have to cut off the fender mounts and make my own to get everything to look right and not just patched together. I also need to mount my wiper motor since I'll be able to retain stock style wiper transmission and not have to go after market making the firewall the way that I did. I think that I'm going to mount my ECM to the firewall behind the supercharger since there is a lot of room there and it will keep the engine bay clean with less wiring.

Anyways, heres some pictures since thats all thats really important lol.