06-08-2019, 10:38 AM
|
 |
Administrator
|
|
Join Date: Jul 2004
Location: Wilton, CA.
Posts: 13,339
Thanks: 7,187
Thanked 2,200 Times in 1,017 Posts
|
|
It sounds like the MSD trigger wire (small red I believe) is not hooked to the ignition switch wire (12 volts when cranking). I would also think the BAT terminal on the switch should go to battery voltage off the fuse box (BAT fuse) or other 12 volts at all times source.
I would connect the red 12V IGN SW PWR wire to the trigger wire from the MSD box, and run a new 12 volt power from the bat fuse or battery to the ignition switch.
|