A few chassis updates.
I drew up a design for the rails that would accommodate the engine setback, and had them bent by Jimmy at MRC Fab just outside Charlotte, NC.
He transferred my design, and quickly rendered it in steel.
Cleaned up and quickly laid it out on the floor - everything will trim to fit.
The whole assembly will be stiffer and lighter than my Rev1 effort. As well, the project will also be documented and published on the YouTubes. A buddy of mine is hosting the videos, and I will continue to manage and keep this thread updated along the way. If you're taking a look, spend some time with Jason's catalog - he's made some really great content through the years.
Post and question, add a comment. Jason and I read them all.
David