After waiting over 12 months for my AMD sheet metal to arrive from the states after a major shipping f**k up the old junk panels were finally removed and the new pieces installed. This included
- full 1/4 panels
- trunk floor + drop off extensions
- outer wheel houses
- rear beaver panel
- rear tail light panel
- doors skins
Basically everything rearward of the fenders was replaced, fortunately the fenders were completely rust free and undamaged save for a little warping on the passenger side.
received_405655243515161
received_312286949402422
received_981056035615468
AMD only supply trunk floors to suit 71-73 camaros, the 70's have a different shape floor and rear parcel shelf setup, so some modification was required to make it all match up. Can't tell it was done now that its been metal finished.
received_379640986160549
received_346963389239387
Everything was epoxy'd before fitting up the outer panels for the final time.
20190301_192540
I couldn't resist putting the wheels on and winding the photos done for some photos, i also trial fitted the new anvil auto tucked bumper and a low trunk spoiler.
20190310_134639
20190310_134848
20190310_134916
20190310_134927
I also have Anvil inner fenders, front spoiler and radiator close out panel on the way.