[bonecrrusher]

Hello everyone - sorry for the long delay- it has been a crazy busy summer.

Picking back up on the Corvette build:

First update - we upgrade the Heat Exchanger water pump on the Corvette - I had the Bosch OEM style pump but those are undersized and underpowered for this application.

So in this episode - we install an EMP Water pump:



Second update:

In a previous episode -we had installed a set of Hinson motor mounts. At the time on the install I didn't realize that they could be prone to failure due to heat - so I picked up a set of Hinson engine mount heat shields - and install them in this episode:



Third update:

After we got the car back together - I went for a test drive and ran into a huge problem. I ended up blowing out the rear main seal - and had to tear the car apart and replace it.



Last update:

Continuing the problems from the last episode - we ran into a huge problem(s) on the dyno: including fuel pressure drop, a Hobbs switch failure, and a TB failure:



Thats going to be it for the Corvette updates - I actually kicked off a build on the SS - I will post those videos shortly.

I am currently working on the Corvette right now - and will get back to posting videos about those projects very soon.