Thanks!
Final update for a little while, instead of going the common DSE subframe connectors, i wanted to maximize rear passenger legroom / comfort by offsetting the connectors close to the rockers.
PART_1563193722369 by
Jake Baldwin, on Flickr
I also wanted the connection points to the subframe to look almost seamless with no brackets or bracing protruding out each side.
20190725_161409
20190725_161403
They have also been notched to suit the aftermarket Planted seat rails for my Recaro CS seats i got for an absolute steal! (approx $500 USD).
received_1851106264955855
20190801_170001
The rear seat area was also raised up (as you can see above) to add a tonne of room for mufflers.
20190801_170247
Next plan is to sort the firewall, get a driveshaft made and finish the trans tunnel.
A pet hate of mine with second gen camaros is the top of the cowl that uses the cheap plastic to stop leaves etc getting into the cowl. I plan on adjusting the shape of the openings and creating custom "fake vents" that wont allow any moisture or dirt etc into the cowl. More on that soon
