Quote:
Originally Posted by jmac
Don,
Can you define "low budget" and tell us how you did it?
Thanks!
|
It is the hood vent off a new SS Camaro. Cost around $120. Bonded it in with panel adhesive and had to fabricate some small peak extensions that carried it into the vent. Low cost because it look a relatively small amount of time and money compared to buying an Anvil or Ring Brothers hood.
I have a Ring Brothers Razor hood on my 69. There was an epic oh sh*t moment when I installed the hood and the vent hit the brake master cylinder reservoir hard. It seems they only build manual brake cars. Had to use a remote reservoir master. They may have since relocated the vents to address this issue, not sure.
Don