Sorry, I am a little out of order here. These pics are from when I was !@@#$%$^^ing with the front end sheet metal, while I still lived in WY. I was trying to get it to line up correctly. Needless to say, Angry Johnny made his presence known, with this nightmare.
So, after inquiring about front end sheet metal, what I got from folks was:
Get AMD fenders, they are the best. Well, I bought 2 of them and initially I thought, yes!! They are pretty good, till I started bolting everything up. Then, it didn't look so hot.
First step was to make sure door to body gaps were good.
OK, with door to body set, I just laid the fenders on the car, and they actually looked pretty decent.
Mid gap was not great, but not awful
Passenger side was actually a better fit than the driver side
Alright, then I started bolting up everything else, and the poor fit reared it's ugly head. With the core support, and all the other front end stuff in place, this is what the driver door gap ended up looking like. That is pretty bad
The gap on the grille to the header panel was almost an inch on the driver side. The passenger side was just about perfect.
Now if I took a jack to the bottom of the fender where the lower extensions mount, I could get the grille gap to look good, but it was at the cost of tweaking the fender. It was almost like the core support was too high on the driver side. I had the correct bushings in the correct spot.
