Quote:
Originally Posted by zz430droptop67rs
Fantastic work so far and such a *major* undertaking.
I was wondering if you are worried about rolling the car around without the rear stub axles installed. I have seen the hub/bearing fall apart on other vehicles because of the lack of support the stub axles provide, even just rolling through the shop.
Keep up the great work, I have been following since the beginning.
|
Thank you.
I was concerned at first and I took the half shafts apart so I could put the stubs in, but I rolled it to see if they would loosen up (because I have also seen them come apart) and they aren't even loose. Its been 3 years like this so I'm thinking I'm good to go. I have another set of lower mile bearings that I plan on using when the car gets finial assembled so I can toss these in the scrap pile then.