So we got the laser level setup so we could take some accurate measurements.
Clearly my lift is not level. Haha! I shimmed the jack stands so the car IS level. Then started taking measurements.
The elevation difference f-d is dead on at 8-3/4"
The width J at the back of the rails is 42-5/8" about a 1/4" too narrow
The width G at the front of the rails is dead on at 33-1/2"
The diagonals I match at 66-5/8" about 1/16" short
The length H from the front of the rails to back is 55" about 1/4" short on both sides
Not as bad as I thought. My plan it to slice the rails where the kink damage is and stretch them back a 1/4".
More to come!
CR