[CamaroAJ]

Not much of an update, lacking some motivation to get stuff done and lacking some parts to give me motivation. I did get started on the fuel filler though. I got the area above the tank cut out to make the fill connection. This will be made into a bolt together cover once I have the pipe built. In order to check for enough drop I had to weld the driver inner wheel well in place. I had to finish fitting it a little bit before it was 100% ready to weld in. After that I located a place to put the filler cap. Not where I wanted to put it, but because of how the tank is I was really limited and I didn't want to put it on the body. With that kinda laid out I built a trunk support now that the wheel well is in the correct location.