[Sonar Chief]

Originally Posted by waynieZ

Crap I thought I was reading my doctors report. lol Nice progress.

Thanks Wayne, I think my warranty ran out and everything is breaking now!!!



Not much to show but a whole lot of work to get here .... prime, sand, and repeat multiple times! Filled the low spots and re-primed with SPI epoxy primer then 2 coats of primer/surfacer ... if you really want to see how bad your body work is sand the surfacer w 400 and it shows all the bad areas, ask me how I know,

And I used a SEM Urethane Flexible Foam between the inner and outer layers of the hood where I cut out for the hood vents ... the skin was moving too much when I was sanding. When the directions say 2 minutes cure time they ain't kidding, if you pause to reposition or think the foam cures at the nozzle .... went through 5 mixing tubes





Little more sanding before surfacer ...





2 coats of Primer/Surfacer...





Sanded the hood with 400 grit ... not too bad but needs some putty in a couple spots!



Mandatory for straight body work ...



Thanks for looking ....