This body work is hard work ... but I just pick a piece and get at it. So far the hood, driver fender and lower extension, header, lower valance, and wiper cowl is flat and sanded down with 400 grit ... just need to spray a coat of epoxy on the bare spots and get some Raptor liner on the underside of the fender and Speedtech inner wheel wells.
Pulled the passenger side fender and got it prepped for epoxy. This fender has some rough spots that will require some hammer and dolly work and I'll need to close up the OEM antenna hole ... wish me luck,
Here's some car porn ....
Ths staging area, lol!
This lower patch I bonded in and it's pretty close ...
Sure is nice to work with clean metal ...
I'd get more done if it wasn't so dang hot during the day ... spraying epoxy after dark when it finally cools down.
Thanks for looking ...