We had another minor issue pop up when attempting to test fit oil cooler connections on the Mast oil pan with header clearance for my Ultimate headers, which fit pretty tight against the block to clear DSE subframe. The Mast pan has provisions for built in oil cooler fittings using their 90 degree adaptors. Unfortunately, those adaptors didn’t provide enough clearance and hit the headers. In discussing with Mast, we were able to make another, lower profile 90 degree fitting work in the front port, but the fitting on the rear port was still a little too close for comfort with the headers tightened down.
I ended up having to abandon the use of the Mast circuitry altogether and bought a sandwich style unit from Moroso which will allow us plenty of clearance for the lines and filter should still sit flush with the bottom of the oil pan.
Sent from my iPad using Tapatalk