I took a couple days off the car and finally was able to get a few rides in on the one of my Fat Bikes. I upgraded the fork & tires and man what a difference it has made.
Looking back I should have installed the exhaust and the fuel tank before I mounted the Filter/Regulator. I am not really happy with how close the line is to the tailpipe. Either way I plan to install the DEI heat shield over the line and the fitting but I am still going to see if I can figure out a better way to run the fuel line.
I slid the Filter/Regulator over about 2" and it looks much better. Not sure if this is going to be the final location but I may move it over a little be more.
I also added a 90 Degree fitting and according to Holley tech's this is perfectly fine.
and then this happened !!!
This is the area of the tank that the tailpipe would be within an inch of.
Ugh !!
So I have a couple choices in front of me and they both involve spending more money.
Choice #1 - Have High Speed Welding make me two new Tailpipes.
Choice # 2 - Order the Holley DSE Clipped Corner Fuel Tank
Calling it a night and going into the house and to watch Kindig It Design on Motor-Trend TV